Ceramic Tile Patterns

Posted By admin on November 3, 2010

Cement Board

Three different ways to cut a concrete slab

There are many ways to cut a concrete slab and there are many ways for you to make any thing that you propose, but not all one way may be the best way is why we show three different ways for you to cut a concrete slab and even obtain very good results, let's take a look at these great techniques:

Using a circular saw

This is by far one of the most easy to cut cement board, usually have a circular saw blade abrasive cutting redundant across the board as if slicing through butter but the easiest way is not always the best way, using a circular saw can produce too much dust and debris and depending on the type of blade on the saw is used act of actually cutting through a concrete slab may be too hard on it so if you are unsure about the type of circular saw you, then you can might be a better idea for you to approach this task differently. Some people do not care about their saws and if they break they always have several hundred more to buy one again if this sounds like then by all means go ahead and experiment a little.

Use concrete cutting equipment

Use cutting of cement can be one of the best ways to reduce cement board, this tool is very similar to an electric drill, in fact, the whole is 80% mechanical similar to that of an electric drill with the difference that instead of a drill attachment that has a scissor-like tip. Use concrete cutting equipment is noisy as with a circular saw unless you are doing this all day, then you may want to check out the following option for you to cut through a cement board. In addition, this type of tool can also produce a pile of rubble, but on the positive side has great control over the direction and how that cut across the board and as we all know what we are doing to stop the precision work is really important.

Using a tool only carbide tipped

This is a rudimentary technique used by many people prefer to go old school to cut this kind of tables. This tool looks a lot like a knife to the main difference is in the cutting blade is carbide tipped. First you need to mark the section to cut through of a pencil or marker, make sure you are able to see the line very well. Then, using carbide-tipped tool to start running the blade down the line you just do in order to scrape or cut a clear path, you may have to do this several times until they are able to get across the board. Once that all cuts are complete, then apply pressure to the back of the plate behind the cut line, place the board and take the cutting tool and begin to scrape along the line to separate the board into two pieces. This technique does not produce many wastes and even if you do at midnight will not be as strong as use of the tools mentioned above.

I want to install ceramic tile in the kitchen, I can install cement board over vinyl or removing exhisting